General Function of Cinder Crusher

Cinder crusher through the two-rotor two consecutive broken, no screen of the device, a variety of wet residue can be broken, both water can also be broken out at any time, there is no blocking phenomenon of adhesion, control the material size only Adjust the gap between the grinder hammer can be. General crusher, because the material in the crushing cavity retention caused by blockage, resulting in increased wear related parts, the series crusher completed to avoid the above phenomenon. Coal gangue mill because of its unique design and wide range of applications, also known as non-sieve grinder, slag crusher, cinder grinder, shale crusher.
Cinder crusher, construction waste and other materials crushed, is to use gangue, cinder for brick additives, fuel and the use of waste rock, shale production standard bricks, shale, coal gangue, Hollow brick high-humidity materials primary treatment of major equipment. This machine is mainly used for coal, gangue, slag, slag, limestone, coke, galena, siderite, sphalerite, limonite, compressive strength of not more than 150Mpa material, especially suitable for the material size Require finer, moisture content of larger brittle materials crushing, widely used in chemical industry, power, aluminum, minerals, building materials, mineral processing and other industries.
Cinder crusher work, driven by the motor, the two sets of rotors connected to each other at the same time high-speed rotation, the material in the machine cavity by the upper rotor crushed immediately by the rapid rotation of the lower rotor hammer crushing again, the cavity material Mutual collision, crushed each other to achieve the hammer powder, the effect of powder material to form a discharge particle size of less than 3 mm of cinder particles. This grain size can fully meet the brick manufacturers as the requirements of internal combustion brick.
1, the two-way shaker rotation, through a continuous two-way operation of such shifts can be hammer and grinding between the uniform wear plate, reducing the frequency of replacement parts of downtime. Double rotor upper and lower two crushing, material crushing more thorough.
2, for brittle materials crushing, no clogging, less dust, low noise.
3, to shorten the material in the crushing cavity retention time and improve the service life of wearing parts.
4, hydraulic electric start chassis, safe, lightweight and convenient. Easy to install, greatly improving the degree of freedom of the equipment; maintenance faster, the upper side of the crusher side door can be free to open, making the mill maintenance and replacement of wearing parts become more efficient and convenient.