Pay Attention To These Tips When You Use Metal Crusher

Handling Precautions:
1, Metal crusher fixed operation, should be fixed on the basis of cement. If you often change the workplace, metal grinder and motor to be installed in the angle made of iron base. If the pulverizer with diesel engine power, should make the two power match, that is slightly larger than the power of the diesel engine power, and make the same two pulley groove. The outer surface of the pulley to be in the same plane.
2, before the start of the metal grinder must be checked before the various parts of the connecting bolts are tightened, tightness of the transmission belt is appropriate, the power cord is good. The motor shaft and the shredder shaft are parallel.
3, check the hammer is good, the sieve aperture is appropriate, with or without damage. Hand drag the belt, check whether the spindle rotation is flexible, with or without cards, touch and friction.
4, the boot, the first equipment idle 2-3 minutes, check the rotor is correct, the sound is normal. Only at the rated speed of rotation after the smooth work.
5, the work should always pay attention to the operation of the mill, feeding to be uniform, to prevent obstruction of the car, not a long time overload. If there is vibration, noise, bearing and body temperature is too high, outward spray material and so on, should immediately stop inspection, troubleshooting can continue to work.
6, crushed material should be carefully checked, not mixed with stones, metal and other foreign objects, so as not to damage the machine.
7, the machine is running, the operator shall not leave the unit, nor may be disassembled in the operation of the grinding room to observe the work of the situation, maintenance tools shall not be placed on the machine or filler.
8, the operator should not wear gloves, blocking occurs, forbidden to hand into the fill bucket, the feed should stand on the side of the mill, to prevent the recovery of debris hurt the face.
9, do not stop immediately after the end of the work, should be idle for 2-3 minutes, so that the machine completely discharged materials. After cleaning, maintenance should be carried out.
10, the source through the metal crusher Hammer is the main wearing parts, whether the same direction after the exchange of corners or worn to change the edges and corners to swap the hammer at the same time to replace the whole group.