How to operate peanut sheller correctly?

Agricultural mechanization greatly reduces the labor burden of farmers friends, today to share a common agricultural machinery-peanut sheller . People often see their want peanut sheller  will appear want to buy the desire to order the equipment received immediately after want to show their machine is the best, ignoring the boot before the preparation, do not read the instructions to connect Electric start large quantities of production, familiar with the machinery of most people are aware of the new machines are prepared before the test machine, need to idle a few minutes, novice is easy to ignore him, resulting in mechanical parts between the direct wear and tear, serious Of the machine will not work, we here to remind you that the new peanut sheller  buy back, be sure to carefully check it again, rigorously in accordance with the correct method of operation, manufacturers of peanut sheller  is made of high quality steel forging, equipment Good quality results Factory security assured assured, the finished product rate of 95%, the loss rate of less than 0.3%, is the ideal equipment of your choice.

peanut sheller  rack, fan, rotor, single-phase motor, screen (both size), into the hopper, shaker, triangular belt and its transmission V-belt and other components.

1. Before use, you should first check whether the fastening of the fasteners, fan rotation is flexible, whether the bearing oil. Sheller should be placed in the horizontal ground.

2. After starting the motor, the rotor should turn in the same direction as the tool. First idle for a few minutes to observe whether the abnormal sound, normal operation, can be evenly fed peanuts.

3. Peanut feeding to uniform, adequate, can not contain iron, debris, stones and other debris to prevent breaking the peanuts and cause mechanical failure. When the peanuts covered with sieve surface, the meter can only open the mouth switch.

4. According to the size of peanut selection appropriate screen.

5. The motor can be moved down to tighten the fan belt, increase the amount of air.

6. Operation, people do not stand on the side of the belt drive to avoid injury.

7. Use a period of time, ready to store the machine, it should be the appearance of dust, dirt and internal remnants of the debris and other debris cleared, the belt removed for safekeeping. Diesel oil will be part of the bearing clean, dry and coated with butter. The machine should be covered in a dry warehouse, avoid sun and rain.

8. Should ensure that the transmission parts and bearings have enough oil and regularly cleaned and replaced.