The working principle and operation of centrifugal oil filter

Preparation before use

Check whether the centrifugal oil filter is assembled correctly, if the specific weight ring is appropriate, and check that the brake (brake) is released. Rotating drum body is flexible, with or without stuck phenomenon. Check that the oil level in the tank is correct. Check the recirculation system for proper operation. Check motor rotation. Especially after the first start-up or after overhaul of the motor equipment.

operating

start up

(1) start the separator, if the machine vibration anomalies, should immediately stop, check the drum assembly.

(2) until all parts of the normal, restart the separator. Due to the large inertia of the drum, the instantaneous load at the start of the motor will exceed the rated value and the current rapidly increases. When the separator reaches the rated speed, the current is then stable and below the motor rating. The entire startup process takes about 5 minutes. When the speed meets the main technical parameters of the separator in the specified value, indicating that the separator has reached full speed.

Separation

(1) open the water seal valve, the inlet seal water to the sewage outlet water.

(2) slowly change the valve, to the drum into the waste oil.

(3) to adjust the import of waste oil valve, mediation appropriate handling capacity.

(4) adjust the net oil outlet pressure, into the normal state of separation.

Shutdown

Turn off the heater and switch the valve so that the waste oil enters the settling tank through the recirculation network.

B. Cut off the power supply. If the machine is stopped as soon as possible, the brake can be used after the speed has dropped to 1000rpm. In order to avoid excessive wear of the friction plate, the drum speed of 1000 rev / min or more, as far as possible without the use of brakes.

C. The drum must be cleaned after each work;

CAUTION: Do not release any fasteners on the centrifugal oil filter machine until the drum has completely stopped.

centrifugal oil filter Usage Precautions

1, is strictly prohibited on the ground bolt to boot, reverse the prohibition.

2, crude oil to be added salt water, hydration and then filtered.

3, can not disassemble, pry the machine.

4, into the tank side of the oil filling hole, filling 2 to 3 times daily edible oil to prevent dry grinding bearings.

Other notes:

1; the temperature of the filtered oil is about 70 degrees.

2; the actual operation of the oil filter in the process of stopping the longer, the better the effect of filtering. The more uniform the oil and water mixture, the better the effect of filtration.

3; the new machine when the test machine 10 kg oil filter is about a filter is appropriate, after 3-4 times can be restored to the normal amount of 50 - 60 pounds. Test machine should first use boiling water (boiling water) in the oil filter inside the rotation after washing repeatedly after the idle test machine the best.