The use and installation of peanut oil press machine.Prior to the use of peanut oil press machine, all auxiliary appliances and containers should be prepared in the first place to check and adjust the tightness of the belt.Then start the motor, and make the machine run around 15min to check the rotation speed of the screw.The general speed should be around 33dmin.When the peanut oil mill is working, it is important to pay attention to the meshing of the gears in the gearbox and whether the sound is normal, whether the bearing parts and motors are normal.When the peanut oil mill idling, the motor current should be about 3A.If the current is too high, stop check immediately and then switch on.
After the no-load normal, prepare about 50kg of peanuts, rapeseed or beans, ready to put into the hopper.
Note: when you start to squeeze, the feed will not move too fast, otherwise the pressure in the pressure will increase suddenly. The screw will not move, causing the pressure to jam, and even the crushing of the cage will cause a major accident.As a result of the compression, the incoming material should be put into the hopper evenly and slowly, and the peanut oil mill can run.This is repeated many times, lasting 3 ~ 4h above, make hengtong mechanical peanut oil press the temperature gradually rises, even take a green smoke (this is normal phenomenon).At the beginning of the squeeze, the temperature of the squeezed chamber is low, but it can be slowly twisted. The handle on the stud of the stud will increase the thickness of the cake, and increase the moisture of the raw material and the temperature of the pressed chamber.Rose to about 90 ℃, the normal operation of peanut oil press, the cake thickness can be adjusted to 1.5 ~ 2.5 mm, and will tighten nut and tighten.
peanut oil press machine, after using it, it must be disassembled and cleaned regularly, so how can we install the correct installation after disassembly in our daily life?
1. Deal with the newly purchased peanut oil press machine for thorough cleaning before installation.Remove the spindle, remove the cage, and polish the outer surface, inner surface and screw feeder.
2. Lubricating grease in all lubricated parts shall be lubricated in gearbox and the varieties and number of the lubricants shall conform to the requirements of the specification.After the circular row is polished and polished, it must be arranged according to the original position in the installation, which can't be misaligned, because the arrangement position and sequence of the round rows have great relationship with oil oil performance.
3. peanut oil press machine, the packing of the round plate shall be pressed tightly with the compression nut, and the degree of compaction shall be used when the disc is pressed for oil.After peanut oil press machine has been processed, the anchor bolt will be used to anchor it.
4. At the time of installation, the pulley of the motor should be aligned with the belt wheel of the peanut oil mill. The position is moderate, the rotation direction is correct, and the tightness of the belt should be adjusted properly.
