Hydraulic sesame oil press machine is how to test machine and press oil operation?

Hydraulic sesame oil press machine after the purchase, in the formal production before the test machine should be running, only after a reasonable normal run in order to make the production more smoothly, the oil rate to normal. And in order to improve the efficiency and quality of Hydraulic sesame oil press machine  to ensure the use of product performance and service life, we have to use the product correctly, so as to play the use of Hydraulic sesame oil press machine  value, reduce the use of cost, so the hydraulic press operation becomes very critical The Hydraulic sesame oil press machine is how to test machine and press oil operation?

Place Hydraulic sesame oil press machine in the specified position and press the following method:

Wiring: from the electrical cabinet connected to the four-core cable, one of which is connected to the zero line, the other three connected 380v power supply to ensure that the motor in the direction of the arrow, if reversed, please switch any two 380v power cord

Add hydraulic oil: remove the fuel tank cover on the two M12 screws, open the fuel tank cover to add 46 hydraulic oil 30-35 kg, to ensure that the oil clean, add a good after the fuel tank cover.

Test machine: to ensure that the power supply connection is correct, press the Kai-long button, the pump began to work, press work, the piston rises, when the pressure gauge indicates the pressure reaches 60Mpa, the black relay automatically disconnect the motor Power, the motor stopped into Baoya state, in the test machine can be a period of time to check the equipment for the lack of equipment and back to the oil to imagine.

Hydraulic sesame oil press machine  the oil extraction process is as follows:

Open the heating switch, spring and autumn use, the temperature adjusted to 70-80 degrees, summer use, heating temperature adjusted to 50-60 degrees, and other heating temperature reaches the preset temperature, open the roof, start the machine, remove the upper plate, put Into the oil pad, move the operating rod to the piston down to the original position, the treated oil poured into the barrel, add the oil pad, cover the upper plate, close the roof, the joystick back to the main valve The putter pops down, presses the start button, the machine starts to press, and the pressure starts to press the oil.

After confirming that no oil has flowed out, press the stop button and pull the joystick to lower the pressure. When the gap between the top plate and the upper surface of the bucket is created, the top plate is pulled open quickly and the joystick is pushed off.

Press the start button, the host work, sick began to rise, with oil cake rose after the barrel, press the stop button, the machine stops working, remove the cake, complete a job.

Note: walnut, pine nuts and other high oil content of the oil in the press to ensure that the filter cloth, add the barrel press (cold pressed oil containing no more than 5%).