Author: Admin View: Post Time: 2017 / 05 / 12
Centrifugal Oil Filter Prepare before use, check that the machine is properly assembled, check that the counterweight is suitable, and check that the brake (brake) is released. Turn the drum body is flexible, with or without jamming phenomenon. Check that the oil level in the tank is correct. Check that the recirculation system is normal. Check the motor steering. Especially after the first start or motor equipment overhaul.
Centrifugal Oil Filter operation: start:
(1) start the separator, if the machine vibration is abnormal, should immediately stop, check the drum assembly.
(2) to be part of the normal, restart the separator. Due to the large inertia of the drum, the instantaneous load of the motor will exceed the rated value and the current will increase rapidly. When the splitter reaches the rated speed, the current is stable and below the motor rating. The whole start-up process takes about 5 minutes. When the speed meets the specified values in the main technical parameters of the separator, it indicates that the separator has reached full speed.
Separation
(1) open the water seal water valve, water into the water outlet to the sewage outlet.
(2) slowly change the valve, add dirt to the drum.
(3) mediate the oil inlet valve, mediate the appropriate amount of treatment.
(4) to adjust the oil outlet pressure, into the normal separation of the state.
Centrifugal Oil Filter downtime
Close the heater, switch the valve, so that the waste oil through the recycling system into the sedimentation tank.
Turn off the power supply, if the separator as soon as possible to stop, can be reduced to 1000 r / min after the use of brake (brake). To avoid excessive wear of the friction plate, the drum speed is over 1000 rpm and the brake is not used as much as possible.
After each work must be cleaned drums;
CAUTION: Do not loosen any fasteners on the machine until the drum is completely stopped. Centrifugal Oil Filter machine leading the world of technology, cast a safe future.
