The use of peanut oil press machine and installation

Peanut oil press machine before use, first of all should be ready for all equipment and containers, check and adjust tightness belt.Then start the motor, the machine idle running about 15 min, check squeezer shaft speed.General speed should be around 33 dmin.peanut oil press machine at work, idling attention should be paid to the gears in the gear meshing and the voice is normal, the bearing parts and motor is normal.peanut oil press machine when idling, motor current should be around 3 a.Such as high current, should immediately stop check, adjusted to boot.
No-load normal after prepared 50 kg of peanut, rapeseed and soybean, ready to put into the hopper.
Note: when you start squeezing feed too fast, or squeeze the pressure in the chamber is a sudden increase, squeezer shaft turn, block, pressing chamber even break the press cage, major accidents.Therefore began to compression, feeding should be uniform slowly into the hopper, the running-in peanut oil press.So repeatedly for more than 3 ~ 4 h, the hengtong mechanical peanut oil press machine temperature gradually raised, and even emit smoke) (this is normal phenomenon.Began to squeeze squeeze chamber temperature is low, but slowly twist, conditioning section stud on the handle, increase the cake thickness, and at the same time improve the squeeze the moisture of the embryo, to squeeze the chamber temperature.Rose to about 90 ℃, the normal operation of peanut oil press, the cake thickness can be adjusted to 1.5 ~ 2.5 mm, and will tighten nut and tighten.
peanut oil press machine, after used, it must be regularly remove, clean up, so we, in our daily after disassembly, how to properly install?
1. Hengtong mechanical peanut oil press machine before installation to new peanut oil press for a thorough cleaning.Take out the spindle, discharge on the press cage, with emery cloth will squeezer inner surface and outer surface, the spiral feeder burnish is bright and clean.
2. Deal with peanut oil press machine, all filling grease lubrication parts, gear box of the lubricating oil, the varieties and grades should be accord with the requirement of the directions.Round after grinding smooth, must according to its original position when installed, can't, because the circle in the arrangement of the position and order of oil performance relationship is great.
3. peanut oil press machine, circle line installed with gland nut after compaction, the compaction degree with the disc in oil can creep advisable.Hengtong mechanical peanut oil press after the above processing, can be used the anchor bolt should be fixed on the base.
4. Best Hengtong mechanical peanut oil press machine at installation time, the motor pulley with peanut oil press machine pulley alignment, moderate position, rotating in the right direction, firmness of belt should be adjusted appropriately.