Operation Instruction of Sesame Oil Press Machine

1. Before use, you must carefully read the operating instructions, familiar with the machine's performance characteristics and methods of operation.
2. Before starting, a comprehensive inspection must be carried out. The fasteners shall not be loosened. The handle is flexible and the pulley shall be turned by hand. The running parts shall be normal and no abnormal sound shall be produced. Then 30 # oil shall be filled in the reducer.
3. Loosen the lock nut, turn the adjustment screw counterclockwise, (adjust the handle counterclockwise rotation, the cake gap narrowed, adjust the handle clockwise rotation, the bread gap widened) to squeeze the screw surface of the cone against the cake And then turn the adjustment screw clockwise (spin out 3-5 turns), and then tighten the nut, ready to boot.
4. Three-phase four-wire power supply connected to the machine, the mainshaft should be rotated counterclockwise after the power is turned on. In any case, the machine must have a good grounding device, otherwise it can not boot.
5. Adjust the temperature controller (2) transferred to the pressing temperature required 120 ℃ -180 ℃ (according to the oil may be) to open the heating switch to the host heating position, the machine heating temperature, then the temperature controller on the green light, The red light goes out, when the machine temperature rises to the set temperature, and the green light is off, the machine's temperature is automatically controlled and maintained at the set temperature, the winter temperature is low, the heating switch to the host all the heating position, So that oil pan temperature, easy to leave oil.
6. Press the main motor button, (the host switch to the positive position) the host to start running, the direction of rotation should be counter-clockwise rotation.
7. After the installation of the new press oil press 4-8 hours, is to use the cake has been drained of oil from the hopper slowly feed, repeated back to squeeze, so that the grinding chamber grinding, remember to start grinding press not to Material directly into the hopper, and to grasp the feed is appropriate to prevent the squeeze screw stuck. Such as feeding too much, pressing the chamber of abnormal sound or squeeze the screw stuck, should immediately stop, eliminate obstruction, or re-assembly and then start grinding press, forcible trailer is strictly prohibited.
8. Normal oil squeeze, you must keep the feed evenly, not too much too little or broken material idle. At this time the machine load is normal, smooth operation, the sound rhythm.